Cone crusher can be widely used in metallurgical industry, construction industry, road construction industry, chemical industry and phosphate industry. It is suitable for crushing hard and medium-hard ores and rocks, such as iron ore, copper ore, limestone, quartz, granite, Sandstone etc. The installation process of the cone crusher is as follows:
1. The quantity of parts must be counted before installation. Check and remove the damage caused to the machined surfaces and threads of each part during loading, unloading and transportation, and remove the protective coating applied on the machined surfaces during packaging as well as the dust and dirt that fell during transportation. 2. During installation, apply dry oil on the fixed contact surface and thin oil on the movable surface. 3. The crusher must be installed on a stable reinforced concrete foundation. The depth of the foundation can be determined by the user based on local geological conditions. 4. In order to avoid the accumulation of crushed ore, there must be enough space under the foundation to install transportation equipment. 5. In order to prevent the foundation from being damaged, the upper part of the foundation must be covered with a protective plate, which must be prepared by the user. 6. Installation of rack (1) Strict verticality and horizontality should be maintained when installing the rack. You can use a level and a hanging weight on the annular processing surface of the base to check the centerline of the base. (2) After adjusting the level of the base with the adjusting wedge iron, tighten the anchor screws and perform the second propeller filling. (3) When the secondary impeller layer hardens, take out the adjusting wedge iron from under the base of the crusher, fill the gap with cement, and then install the frame. 7. Installation of drive shaft (1) When installing the cone crusher drive shaft, an adjusting gasket should be placed between the base and the flange flange of the drive shaft frame. (2) After the transmission shaft is installed, use a template to check the dimensions related to the transmission gear. (3) The axial movement of the transmission gear should be 0.4-0.6mm (that is, the gap between both ends of B). (4) When disassembling the drive shaft, you can use the drive shaft frame flange.
