Cone crusher wear parts include:
- Cone crusher mantle, which covers the cone head of the crusher to protect it from wear. It is the inner sacrificial wear liner that sits on the cone head.
- Cone crusher Concave, which sits in the upper frame of the crusher to protect it from wear. It is the outer sacrificial wear liner that sits inside the upper frame.
- Torch ring. The lock nut and the mantle are transferred and sealed by the welding torch ring. At the same time, the torch ring is also used as the destruction body when the movable cone lock nut is removed.
Cone crusher liners selection
A wide range of liners are available to accommodate coarse and fine feeds, but which you choose depends on several factors.
- Feed sizes. The most important factor in Cone Crusher liner selection is the feed. You should have a well-graded feed going into the crushing chamber. A well-graded feed is generally considered as 90-100% passing the closed-side feed opening. Some people look at 80% of the open side as well and select the smaller of the two; 40-60% passing the midpoint; 0-10% passing the closed-side setting. You want to match the entire feed gradation, not just the feed size so that you utilize the entire chamber. It is important to utilize as much of the crushing chamber as possible to get the required reduction and desired throughput. Plant feed size and the output from your previous crushing stage define your top feed size, which will give the maximum cavity opening. The cavity opening should not be too big in relation to the top feed size. Cavity openings that are much larger than the feed size leads to poorly utilized reduction and liners. If the feed size is too small, the majority of the crushing takes place in the lowest portion of the cavity, which means the bottom of the liners will wear away faster than the top of the liners. The production will decrease due to the poor reduction ratio. The power limit of the crusher will be exceeded at a minimal volume level, and you`ll run the risk of improper bearing alignment. Most of the wear on crusher liners occurs right before the parallel zone (the smallest space between the mantle and the concaves where the final crushing takes place), but this wear will be accentuated if the feed is too small, and you`ll end up with a bowled-out pocket before the parallel zone way too soon. On the other hand, if the feed size is too coarse, the feed material will keep percolating around the feed opening, causing the top of the liners to wear away faster. Because the feed opening is bridged over, throughput is reduced and production decreases. The output gradation will be coarser, and the product will be slabby, not cubical. The volume limit will be exceeded at a minimal power draw. Understanding your gradation going into the crusher helps you to choose the right liner configuration necessary to achieve your production goals. The right liner selection gives you a better nip and more room to adjust other parameters, such as a closed-side setting.
- Feed grading. The maximum feed size is important as if there are a lot of fines in the feed or a lot of single sizes in the feed, it can cause issues with wear and output. Attention should also be given to recirculating stone for the following reasons: It has a tendency to be a lot more abrasive and harder than virgin stone; Depending on the amount recirculating, it can cause issues with the segregated feed.
- Output required. This takes into account output and grading required, which can affect which crushing chamber you should select.
Cone crusher liners cavity selection
Different brands of cone crushers, different cone crusher liners cavity types. There are some famous brands of cone crusher liners cavity types:
- Metso cone crusher liners cavity
- Sandvik cone crusher liners cavity
- Terex cone crusher liners cavity
